How to Paint Teak Wood
One of the motives for the use of teak — specially for outdoor fixtures — is its abundance of herbal oils. The oils save you rot and provide the wooden a glittery patina, however additionally they inhibit paint adhesion and might bleed thru finishes, so painting teak isn’t the quality idea within the world. You may additionally have a few achievement, though, if the wooden is antique and weathered. Proper education is crucial, and it doesn’t harm to seal the timber earlier than painting.
for watch detailed video about How to Paint Teak Wood, see below. for getting daily updates follow our facebook page and click see first option in following button. if you interested this. give this post to your friends and relatives.for more videos, subscribe now:PLANET OF VIBE
Wash the Wood
You don’t need to worry about sanding off the layer of gray timber that discolors old teak that has been exterior, but you do need to scrub the wood thoroughly to remove dust, excess oil and mildew which can interfere with paint adhesion. This is a task for a robust detergent; mix 1/2 to one cup of trisodium phosphate in a gallon of warm water and wipe down the wood with it, using an abrasive sponge. Wear rubber gloves and goggles while operating with TSP, and rinse the wood thoroughly with easy water after you have washed it.
Fill Holes and Scuff
Sanding teak earlier than portray it isn’t always vital, but as additional insurance in opposition to peeling, you should scuff the wooden with 220-grit sandpaper. Before doing this, fill gouges and holes with epoxy wood filler, so they might not be visible after you paint. To use epoxy filler, blend it with the hardener that comes with it in the endorsed proportions and spread it with a putty knife. Use it within 5 mins of mixing to make sure it remains pliable, and sand it flat with a hundred and twenty-grit sandpaper after it units.
Apply Stain-Blocking Primer
The natural oils in teak — just like the sap in knotty pine — will bleed thru a paint coating and want to be sealed with a primer. Some high-solids latex primers will do the activity, but to be on the safe facet, prime with a shellac- or lacquer-based totally product. Apply the primer with a natural-bristle paintbrush, brushing with the grain of the timber, and let it dry earlier than touching the wooden. If you can, look ahead to per week earlier than proceeding to look if the oils bleed thru the primer. If they do, observe any other coat before portray.
Paint at Least Two Coats
Even if you tint the primer a colour near that of the paint you’re the use of, you may need at least coats of paint. Choose both latex or oil-primarily based paint — both may be applied over shellac-primarily based primer. Brush a single coat with the grain of the wood, the use of a artificial-bristle brush for latex paint and a natural-bristle brush for oil-primarily based paint. Scuff the first coat of paint after it dries; then follow a 2d coat within the identical manner. To provide your paint activity extra protection, finish off with an non-obligatory coat of clear polyurethane.
