How to Build Your Own Homemade Bathtub

Building your own bathtub is not an cheaper or clean manner, but it is able to be accomplished. Tubs can be constructed from wooden, concrete or tile-included masonry. Probably the easiest is to build a bath with concrete backer board and tile it. A home made tub will typically fee greater than a bought bath, but can be fashioned to fit an uncommon space or made longer, taller or wider than wellknown tubs.

for watch detailed video about How to Build Your Own Homemade Bathtub, see below. for getting daily updates follow our facebook page and click see first option in following button. if you interested this. give this post to your friends and relatives.for more videos, subscribe now :Home tech

Step 1
Lay out the size and form of the bath and build a body of two-through-4s. Join the lumber the usage of butt joints and as a minimum 3 screws in line with joint. The minimal spacing of the framing lumber need to be 16 inches. Install facet partitions at right angles to the ground, but attitude the back of the tub so this is relaxed to lean against.

Step 2
Rough-in the plumbing for the drain and faucet. Install layers of 19/32-inch exterior grade waterproof plywood on the floor of the bath to offer ok support. Offset joints as a minimum 6 inches.

Step 3
Cut a 4.Five-inch hole in the plywood where the drain will go. Disassemble the drain and lay the drain base within the hollow so the flange of the drain base rests at the plywood. Solvent weld the drain base to the drain pipe. Cover the drain base opening with duct tape to maintain materials from falling into the drain.

Step 4
Fasten concrete backer board to the frame using screws designed for concrete backer board. Space the screws every 6 inches. Cut and in shape the backer board as tightly as possible to make it less complicated to seal the bathtub. Cover the joints with adhesive and right now embed backer tape.

Step 5
Apply Portland cement/sand mortar mix over the floor of the bathtub so that it slopes toward the drain at 1/four inch per foot. The mortar bed should be flush with the pinnacle surface of the drain base.

Step 6
Trowel a thick, clean layer of waterproofing over the whole bath to at the least 2 inches above the overflow drain. Allow that to dry, after which upload another coat. When the second coat is dry, vicinity the clamping ring for the drain over the bolts and slide the ring counterclockwise till it’s far tight. Plug the drain; fill the bath with water and allow it sit for at the least 4 hours. Drain the bath and restore any leaks before intending.

Step 7
Place pea gravel over the weep holes inside the drain assembly so mortar does no longer completely block them. Determine the finished peak of the floor of the bathtub and screw the drain barrel and strainer into the clamping ring in order that the drain barrel can be flush with the bottom of the bathtub.

Step 8
Lay a 1 half-inch bed of mortar on the tub floor. When it’s miles dry connect multiplied metallic mesh 2 inches above the water line and cowl the edges of the tub with half inch of mortar. Allow the mortar to treatment before installing tile.

Step 9
Install tile the use of thin-set mortar. Lay tile on the bath floor first, cutting tile to suit across the drain and to accommodate the slope. Install the cove tile inside the corners wherein the ground meets the wall. Use a straight facet to start and a level to make certain you keep the tile level because it rises up the edges of the tub. When the mortar cures, fill among the tile with grout. Mix seventy five percent sanded grout and 25 percent nonsanded grout.